Call us — 0131 202 0491
Mon–Fri · 9am–5:30pm · No fix, no fee
Start a free diagnostic →
Service · water & fire

After the flood, before the panic.

A pipe bursts above your home office, a basement floods in a rainy Scottish winter due to being near a river, or your house catches fire and, while it spares the safe, it cooks all of the rest. Disaster media has one comfort: hard drive platters and flash chips are way tougher than the computer and electronic components surrounding them. However, the recovery rules for disaster media are counter-intuitive, so read this first, before you dry anything.

two decades’ experience
In-house, never outsourced
Only pay if we recover your data, on most jobs
// water rules

Wet drives: do not dry them out.

The idea of a radiator, airing cupboard or rice is dead wrong. Drying deposits minerals and contaminants from the water as residue on the connector and, if water entered into the drive, on the platter surface, where dried crud does more damage than the wet had done. Floodwater especially is not clean. Never turn it on (electricity plus moistened electronics will finish off the work of water), seal it up in a plastic bag (for laptops or PCs, simply the drive; a plastic bag with dampness is perfectly acceptable), get a quote first, over the telephone or via our contact form, then get it to the bench, where controlled cleaning removes contaminants before any data recovery takes place. Wet-recovery drives have an excellent outcome; dry-and-try drives make up the sad half of the statistics.

// fire rules

Heat, soot, and what survives.

Fire damages storage units in three different ways: direct fire damage to components (the plastic casing of your drive will melt before the data can be lost due to demagnetisation, and a melted case often hides recoverable metal); soot from fires (soot is conductive, invades your equipment and causes electrical shorts in areas where you may still have functional boards); and finally, after the fire has been put out, what's left behind: the chemical residues from extinguishers and the water used to fight fires, which are also destructive to computer components. The same procedures apply as those for a flood: do not attempt to turn on your unit; do not clean anything; place it in a protective covering (bag), then call us by phone to get a quote or complete our quote form, and bring it in. No appointments are necessary; we're open Monday to Friday, 9am to 5:30pm. Even if your unit appears completely destroyed, there is no cost associated with obtaining a diagnosis. Our technician may surprise you with a diagnosis that is better than expected. For businesses: this pairs with the emergency track when the damaged media is the operational one.

// questions

Asked often, answered straight.

Not necessarily, but stop at that point, and most importantly do not power it up to see if it works. Drying deposits residue, and power will find it. Bag the drive in its current state, get a quote via phone or using our quote request form, and send it; controlled cleaning can correct many problems better than you might think. Either way your diagnostic conclusion remains complimentary.

Yes, recovery results are documented as standard and we can provide written verification to an insurer of the physical state of the unit, what could be recovered and what couldn’t, in a format acceptable to an insurer. Just mention the claim when you book it in and your paperwork will adjust accordingly.

There is no cost, therefore yes, and melted exterior casings typically conceal good data-bearing media, which can take much more heat than plastics. Get a quote by phone or use our online quote request form, then send us the drive (not the laptop; a computer shop can take it out). We do not repair or attempt to salvage boards with soldered media, and we will let you know if this is the case prior to sending. In extreme cases we have successfully retrieved data from units sent to us in freezer bags with multiple components. At worst, you receive a conclusive, documented no.

0131 202 0491